ClearSounds 40XLC Installation Guide download pdf (Page 11)

Installation Steps

Installation of your ClearSounds™ 40XLC Ampliﬁed Phone is easy. There are some basic

steps you need to take when you set-up your 40XLC Phone for the ﬁrst time.

1. Check parts list.

(See page #5 for complete list)

2. Install (4) AAA Alkaline batteries (not included). This provides power to the Caller ID

Screen.

3. Set the dialing mode.

4. Choose desktop or wall mount.

5. Set ringer and auxiliary alert.

6. Program your memory dial buttons.

INSTALLING THE OPTIONAL BATTERIES

The batteries are necessary in case of network power failure to save stored numbers in

memory and are required for the “Phone Book” use.

1. Open the battery compartment door located on the bottom of your phone by un-

screwing the battery compartment door and removing it from the bottom of your

phone (screwdriver provided).

2. Insert correctly 4 AAA alkaline batteries (purchased separately) in the battery com-

partment (See ﬁgure #6). Be sure to observe battery polarity as imprinted on the base

of the compartment.

3. Replace the battery compartment door and screw back in place.

4. The batteries will last approximately 1 year before needing replacement.

NOTE: Always unplug the line cord before installing new batteries.

SETTING THE DIALING MODE

Set the dial mode switch on the bottom of the phone to “T” if you have Touch Tone service,

or “P” for Pulse dialing if you have rotary dialing service. Default is set to the “T” dialing

switch mode (See ﬁgure #7).

Figure #

6 – Installing the batteries

Figure #7

– Dialing mode switch

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

No comments

ClearSounds 40XLC Installation Guide Page 11