ClearSounds CLA7 Troubleshooting Guide download pdf (Page 14)

14 – ENGLISH

6. Holding the phone slightly above the mounting screws

on the wall jack, push the phone against the mounting

screws so they are hooked into upper and lower keyhole

slots on the back of the phone. Slowly slide the phone

down until it snaps into place (see Diagram 8).

7. When mounting the phone on dry wall without a standard

telephone wall plate, install 2 self-tapping screws (not

supplied) at a distance of 167.5 mm (6½ inches) from

each other and located on a vertical line. Place the

phone onto the screw-heads and slide down to secure

(see Diagram 9 & 10).

8. Plug the AC power adapter into the electrical outlet.

CAUTION: To reduce risk of personal injury, fire, or

damage use only the adapter provided (MODEL AD-

101UA) listed in the user’s guide.

9. Connect the handset using the coiled handset cord and

listen for a dial tone. If you hear a dial tone, your phone

is ready to use. If there is no dial tone, check all your

cords to make sure they are plugged in securely and re-

check installation steps.

█

Using the Amplification Function

Your ClearSounds® CSC1000 is equipped with a specialized

amplification function designed to adjust to your needs.

You may press the Amplify key to temporarily increase the

volume of the handset during a call. To return to normal, press

the key again. Volume levels will also return to normal when

the handset is replaced on the base after the call. Once the

Amplify key is pressed, an extra level of amplification and

tone enhancement is added. During a call, adjust the Volume

control and Tone control on the front panel of the phone to fit

the levels to your hearing requirements. The volume control

BASIC TELEPHONE FUNCTIONS

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

No comments

ClearSounds CLA7 Troubleshooting Guide Page 14