ClearSounds v407 Installation Guide download pdf (Page 9)

Page 6

Wall Mounting

1. Turn the phone over so that you are looking at the bottom of the phone. Insert tabs at

the thin end of the wall mount bracket into the holes at the

rear of the phone bottom. Press and latch the tabs at the

thicker end of the wall bracket into holes at the front end of

phone. The back of the phone should then have two round

plastic holes that can be used to hang your phone on the

wall.

2. Use the two round holes to hang the phone on the wall plate on your wall.

Important Note: If you do not wish to mount your phone on the wall, the Wall Mount

Bracket can be reversed to raise the angle of the phone's display when sitting on a table

or desk.

Adjusting the Display Angle

You can optimize the LCD display by adjusting the viewing angle. To adjust the LCD

viewing angle, move the rear edge of the LCD module up or down.

Adjusting the Display Contrast

The display can be adjusted to suit the light level of your room and your viewing

preference. To make the contrast of the display lighter or darker, press the ◑ button to

the right of the screen until the desired contrast is reached.

Adjusting Handset Receiver Volume

To adjust the handset receiver volume:

1. Lift the handset and listen to the dial tone.

2. Press the Volume up button to increase the receiver volume.

3. Press the Volume down button to decrease the receiver volume.

4. Replace the handset when the desired receiver volume is reached.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 69 70

No comments

ClearSounds v407 Installation Guide Page 9