ClearSounds v407 User Manual download pdf (Page 11)

Installation Steps

Installation of your ClearSounds™ CSC50 Ampliﬁed Phone is easy. There are some basic

steps you need to take when you set-up your CSC50 Phone for the ﬁrst time.

1. Check parts list.

(See page #5 for complete list)

2. Install (4) AAA Alkaline batteries (not included). This provides power to the Caller ID

Screen.

3. Phone mounting installations.

4. Set the dialing mode.

5. Choose desktop or wall mount.

6. Set ringer and auxiliary alert.

7. Program your memory dial buttons.

INSTALLING THE OPTIONAL BATTERIES

The batteries are necessary in case of network power failure to save stored numbers in

memory and are required for the “Phone Book” use.

1. Begin by unplugging the AC adapter & line cord before installing new batteries.

2. Open the battery compartment door located on the bottom of your phone by un-

screwing the battery compartment door and removing it from the bottom of your

phone (screwdriver provided).

3. Insert correctly 4 AAA alkaline batteries (purchased separately) in the battery com-

partment (See ﬁgure #10). Be sure to observe battery polarity as imprinted on the

base of the compartment.

4. Replace the battery compartment door and screw back in place.

5. The batteries will last approximately 1 year before needing replacement.

BATTERY SAFETY

1. When replacing the batteries in your CSC50 phone, make sure to put the batteries

in correctly (See page above).

2. Never mix battery types (different chemistries, brands and/or fresh vs. used).

3. Never dispose of batteries in ﬁre, as they could explode.

4. Remove worn-out batteries from equipment immediately and dispose of promptly.

5. Do not attempt to recharge a battery unless the battery speciﬁcally is marked

“rechargeable.” Dispose of immediately.

Figure #

10 – Installing the batteries

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 107 108

No comments

ClearSounds v407 User Manual Page 11