ClearSounds v407 User Manual download pdf (Page 32)

Call will not dial or dials very slowly

1. Check that the phone is in the correct dialing mode, Touch-Tone / Pulse Setting (See

page #14)

No audible ringer

1. Make sure the ringer is not set to the “OFF” position (See ﬁgure #8).

2. Check the volume level of the ringer.

3. You may have too many extensions on your line. Try unplugging a few devices.

Having too many telephones /accessories can also create problems such as low

ringer volume or impaired quality during calls.

No Strobe Ringer and/or bed shaker will not activate

1. Make sure the strobe and/or shaker switch is turned “ON”

(See ﬁgure #12).

2. Make sure the Bed Shaker is plugged in all the way.

3. Make sure the Bed Shaker is plugged into the correct jack (See ﬁgure #11).

No ampliﬁcation

1. Check to see if the AMPLI amplify button is “ON” (See ﬁgure #24). The red light should

be lit.

2. Check the AC Power Adapter and make sure it is plugged into the wall and into the

appropriate jack on the phone.

Noise, Static, Interference while using the handset

1. A ﬁlter may be required for homes with DSL line or near Radio towers.

There is a red light that continues to ﬂash

1. You have un-reviewed Caller ID / Call Waiting information or missed a call (See

page #24).

2. Your Voice Mail account needs to be set-up as Visual Indicator only. Contact your

local phone company; if the account is setup as Audible or Audible/Visual indicator,

the light will contine to ﬂash after reviewing your voice mail messages.

Difﬁculty storing numbers in memory

1. Make sure you are pressing the correct sequence of buttons for storing numbers.

2. If you are interrupted by the telephone company’s recorded announcement telling

you to hang up or by a loud buzzing noise, ignore and continue to store the num-

bers. Or hang up and store the number without lifting the handset or temporarily

disconnect the telephone line until you have programmed in all the numbers.

No numbers dialed when memory button is pressed

1. No number stored in that memory button.

Make sure phone number was programmed and saved in the memory (See pages 16).

3. Make sure programming is done in the correct dial mode (touch-tone or pulse dial-

ing).

4. If your phone has been disconnected for a few hours the numbers stored will be

lost.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 107 108

No comments

ClearSounds v407 User Manual Page 32